Shower Door Maintenance Guide

Glass shower doors do not wear out — they get coated. Soap scum, minerals and body oils build a film that looks like cloudiness in the glass but is actually on it, and once it hardens it takes real work to remove. Two habits prevent almost all of it.

Squeegee after every shower

Sixty seconds with a squeegee removes the water that carries the minerals. This is the whole secret to a door that stays clear for years.

Clean weekly, not monthly

• Spray a 50/50 white vinegar and water mix, or a pH-neutral glass cleaner, onto the glass.
• Wipe with a microfiber cloth, then rinse and squeegee dry.
• For light soap film, a paste of baking soda and water lifts it without scratching.

Never

• Use abrasive powders, steel wool or scouring pads — they scratch glass and dull aluminum frames permanently.
• Use acid-based descalers on metal frames or seals.
• Use a razor blade at an angle on tempered glass; a plastic scraper is the safe tool.
• Let cleaners dry on seals or gaskets — they harden the rubber.

Track and rollers

• Vacuum or wipe the track weekly. Hair and grit in the track is the main cause of a door that starts sticking.
• Wipe rollers with a damp cloth; do not oil or grease them unless the manufacturer specifies it, since oil attracts dust.
• Check the top rail fixings every few months — a door that starts to sag is usually a loosened screw rather than a failed roller.

Seals and gaskets

Bottom sweeps and magnetic seals are wear items. If water starts escaping at the base, replace the sweep before assuming the door is at fault — it is an inexpensive part and usually the whole problem.

Glass breakage from impact is not covered by warranty; defects and transit damage are. See the shower door warranty, or email info@northern-breeze.com for a replacement part.